Pc-concepts SHG2 DP User Manual download pdf (Page 15)

Intel® SHG2 DP Server Board Technical Product Specification Introduction

Revision 1.0 Intel Order Number C11343-001

Server management and monitoring hardware are also included. These features, and the

others listed below, make this one of the most highly integrated server boards in this class.

SHG2 supports two interleaved memory channels at 100 MHz, each utilizing the rising edge

and falling edge of the clock cycle for 200MT/s per channel (also known as “double pumped”)

for a combined throughput of 400 MT/s. The subsystem was originally intended for PC1600

DDR memory modules (DDR200), however up to 6 DDR200 of DDR266 registered memory

modules (PC1600 or PC2100 DIMMs) inserted as pairs may be used. Each DIMM may provide

up to 2 GB of memory capacity, providing up to 12 GB of system memory.

Note: Although the use of DDR266 modules is supported for upward compatibility, the channel

throughput is fixed at 400 MT/s, and the use of higher speed DIMMs will not provide additional

bandwidth. Mixed memory is not recommended, all DIMM sites should be populated with the

same speed and, when possible, same manufacturer.

The SHG2 server board provides the following features:

•

Dual Intel Xeon processor support.

- Two processor sockets for installation of one to two identical Intel Xeon processors.

- Embedded VRMs to support two Xeon processors.

•

ServerWorks Grand Champion LE chipset.

- Champion Memory and I/O Controller-Low End (CMIC-LE).

- Champion South Bridge (CSB5).

- Champion I/O Bridge (CIOBX2).

•

Support for 6 DDR registered ECC Synchronous Dynamic RAM (SDRAM) DIMMs.

- Error Correcting Code (ECC) single-bit correction, and multiple-bit error detection

and memory scrubbing.

- Supports Chipkill* technology

•

32-bit, 33-MHz 5V keyed PCI segment with three expansion connectors and two

embedded devices with external connectors.

- One PCI NIC—Intel 82550PM Fast Ethernet Controller with a dedicated RJ-45

connector at the rear I/O panel

- 3D/2D Graphics Accelerator —ATI* RAGE XL Video Controller with DB15 VGA

connector at the rear I/O panel

•

64-bit, 100-MHz, 3.3V PCI-X segment with two expansion connectors and one

embedded device.

- One PCI-X network interface controller—Intel 82544GC Gigabit Ethernet Controller

with a dedicated RJ-45 connector at the rear I/O panel

•

64-bit, 133-MHz, 3.3V PCI-X segment with one expansion connector and one

embedded device.

- Dual Channel Ultra* 160 SCSI Controller—Adaptec* 7899 SCSI Controller.

Note: When the 7899 SCSI Controller is enabled, this bus segment will run at 66MHz in

PCI mode. When disabled, the segment is capable of 133MHz PCI-X mode.

•

X-bus segment with one embedded device.

- 8-Mbit flash device for system BIOS.

•

LPC bus segment with two embedded devices.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 96 97

Comments to this Manuals

No comments

Pc-concepts SHG2 DP User Manual Page 15

Comments to this Manuals